Scalar Applications

How to Run Scan Results Using Spooky2 Scalar

Spooky2 has four ways of doing biofeedback scan: Spooky2 Pulse scan, Spooky2 GeneratorX TENs scan, Sample Digitizer scan, and Scalar Digitizer scan.

Many people have confusions about how to run these four scan results using Spooky2 Scalar. This article will answer this question in details.

Step1: Choose Spooky Scalar General (SS) – JW preset
Step2: Go to Programs tab, search your scan results and double click to choose it. You will see the scan’s name in the Loaded Program Pane.
Step3: Go to Control tab, tick overwrites generator, click G2 to run your scan results.
Step4: Press start. The channel button will turn green.

Note:
1. When you run scan results, please remove Spooky2 Scalar Digitizer. Then use G2 to run your scan results.
2. Other biofeedback scan results refer to Spooky2 Pulse scan, Spooky2 GeneratorX TENs scan, and Sample Digitizer scan.
3. You can run other biofeedback scan results using Spooky2 Scalar, though original mode would be the best, as that was how the frequencies were applied.

 

Leave a Reply

Your email address will not be published. Required fields are marked *