How to Imprint Substance’s Information into Water Using Spooky2 Scalar

With Spooky2 Scalar, you can imprint substance information.

In this video, we will show you how to imprint substance’s information into water.

If you wish to imprint substance information into water for drinking, place the water on the transmitter coil, and the substance on the receiver coil.

Glass container is recommended for the substances. Take essential oil as an example. Remove the essential oil cap. Place the essential oil on the small grey circle, which is the best place for the substances.

Then place a glass of water on the small grey circle of the transmitter coil.

OK, we can turn on Spooky2 Scalar now. Turn the tuning adjustment knob anticlockwise until the tuning light beside the transmitter coil is at maximum brightness.

It only takes a few minutes to imprint information into a small container. A glass of water could take 10 minutes for more. A larger container would take even longer. You can sit between the transmitter and receiver while scalar is running.

One thought on “How to Imprint Substance’s Information into Water Using Spooky2 Scalar

  1. Sherrie Kay Reimers says:

    Why does the cap of the essential oil need to be removed?

Leave a Reply

Your email address will not be published. Required fields are marked *