How to Imprint Frequencies into Water Using Spooky2 Scalar

Molecular Scalar

In this video, we will show you how to imprint frequencies into water using Spooky2 Scalar.

Firstly, we need to load the program into GeneratorX.
Plug the power adapter into GeneratorX and the other end goes into the power source. Then, connect the USB cable to GX and the computer. Insert the square end into the side of GeneratorX and the USB end into the computer. Turn on the GeneratorX.

Then you can open the Spooky2 software.
Go to Presets Tab, choose Shell presets/Scalar/Spooky2 Scalar General (SS) – JW.
Next, go to Programs Tab, you can load the program that you need, here we search “Cold Coughing” program and double-click to choose it.
Then, go to the Control tab, tick “Overwrite Generator” and open a generator.
Click the “Load” button. Double click to select a memory location to save the preset and click “Save”.

Secondly, we need to set up Spooky2 Scalar devices.
Connect the 12V Power Adapter to the Transmitter Power Port. Then plug the Link Cable into the Transmitter and Receiver.

Thirdly, we need to connect GeneratorX to Spooky2 Scalar.
Connect G1 Out 1 or G2 Out 1 to the BNC port of the Spooky2 Scalar Transmitter. Here we connect G1 Out 1 to this port using a BNC cable.

Fourthly, we need to place the water on the transmitter plate.
We can turn on Spooky2 Scalar now. Then turn the tuning adjustment knob anticlockwise until the tuning light beside the output coil is at maximum brightness.

Fifthly, we need to start the “Cold Coughing” program in GeneratorX.
We connect G1 Out 1 to the Spooky2 Scalar Transmitter, so we press G1 here. You can see all your loaded presets in GX. Select “Cold Coughing”. Press the Start button.

Run healing programs with no more than 8 frequencies. High frequencies should restructure the water in one or two hours and very low frequencies like Schumann Resonance may take a day or two.

If it is low frequency, tuning light will be blinking. If it is high frequency, the tuning light will constantly bright. If the frequency is too high, the tuning light will not light up.

You can stay in the scalar field while imprinting information into water. The water information will then be tailor-made for you.

Leave a Reply

Your email address will not be published. Required fields are marked *