Scalar Research

Pure Wireless Mode of Spooky2 Scalar

Can Spooky2 Scalar be useful in wireless mode? Jeff did a quick test, which based on scalar theory suggested was possible. Please check the details below:

I removed the floating ground link cable and tested to see if I could still get the receiver box to show me that the power was flowing. Some would attribute this to true wireless transmission of power, some will still argue it — to each their own.

In any event, here are two pictures of both the coil tester being energized by the receiver coil without the link cable connected. The picture above shows the coil tester lights up. In the picture below, the LED on the receiver box is turned on, which robs the power to light up — hence the coil tester goes dark. Both of them prove Spooky2 Scalar can work in wireless mode.

Wireless Mode of Spooky2 Scalar-1

Wireless Mode of Spooky2 Scalar-2

Note: It is still better to run the Scalar system with the link cable attached. It makes it less sensitive to environmental factors and easier to tune.

Authored by Jeff Kaczor
Source: https://www.facebook.com/groups/spooky2scalar/permalink/308396016400630/

4 thoughts on “Pure Wireless Mode of Spooky2 Scalar

  1. Fernando Funes says:

    I have problem to verify the receiver antena, giacche the Led light doesn’t come on anymore, I have verified the link cable and it has continuity. could you give me a suggestion to test the operation between transmitter and receiver. thanks
    Fernando

  2. Michael Slivinski says:

    12/09/22
    Hello Jeff,
    I posted on FB , thinking out of the box.
    I removed the receiver, and link cable
    from the usual normal set up. I rotated the S2S transmitter 180 degrees and aime the lid toward another room, where I spend a lot time. I tuned the Transmitter like in normal mode, and the LED on S2S transmitter went bright as I turned it counter clockwise and it looked like it was acting like in the normal set up. I raised the question, speculation thought that the Transmitter is sending, transmitting
    Scalar waves. And it would please me if this were true, because I would use this for just the Scalar effect. Makes it easier, more portable to move around the house, or wherever. Thanks
    Mike Slivinski

  3. Hilary Lau says:

    Is placing a test coil on the receiver coil another additional method of testing the tuning, apart from the receiver light?

    1. Yes, you can. But it is not accurate than method 1 so we strongly recommend you use method 1.

Leave a Reply

Your email address will not be published. Required fields are marked *