When you smoke, the poisons from the tar in the cigarettes enter your blood. These poisons make your blood thicker, increase the chances of clot formation, increase your blood pressure and heart rate. Also, they can narrow your arteries, reducing the amount of oxygen-rich blood circulating to your organs.
The lungs can also be very badly affected by smoking. It can cause fatal diseases such as pneumonia, and emphysema. Smoking does harm to nearly every organ of your body. It causes many diseases, and reduces the health of smokers in general.
Quitting smoking can lower your risk for smoking-related diseases and can add years to your life.
If you have had trouble quitting smoking in the past, you may want to try a different approach with Spooky2 Scalar.
Now, let’s learn how to apply smoking frequency to scalar field.
5 Simple Steps to Apply Smoking Frequency to Scalar Field
Step 1
Load these up below from the database in Spooky2 software
Lung General 1 – 5
Lung General Conditions (XTRA)
Lung General Tonic (XTRA)
Lung General (CAFL)
Lung (XTRA)
Lungs (XTRA)
Nicotine Withdrawal (XTRA)
Nicotine Cravings (XTRA)
Detox Nicotine (XTRA)
Note:
Due to compression to make the database more efficient to search and minimize loading time and space requirements, any programs that had identical frequencies were all reduced to one Program with all other names listed in the Notes.
Step 2
Set up Spooky2 Scalar devices.
Step 3
Connect GeneratorX to Spooky2 Scalar. Tune Spooky2 Scalar.
Step 4
Go to Control Tab to load and run these programs.
Step 5
Sit between the transmitter and receiver while the programs are running.
Note:
You may eventually experience coughing phlegm. This is normal as lungs clean themselves out.
Is it also good to run on Plasma or Remotr?
Yes.