1. The Scalar Digitizer biofeedback scan is a different type of scan. The Scalar Digitizer defines hits by measuring a drop in the electrical component of the scalar field because something in the body is requiring more scalar information to kill or heal. This could be a pathogen, healing or entrainment, or a higher energy blockage, etc.
2. The scan picks up the top 20 hits based on priority – what your body needs most. Just know the electrical component of the scalar field being measured is limited to 500Hz-50,000Hz and therefore the scan range is limited to 500Hz-50,000Hz, so it’s not the same as the much higher freq scans of GX (18 MHz).
3. But they are different. This is a Scalar scan for hits in the scalar field. It still produces a very unique and very accurate biofeedback scan, that penetrates every aspect of the body. When those scan results are reapplied back into the scalar field with GX, it smothers the body with the scalar information the body needed.
For more details, please check this link: https://www.facebook.com/groups/spooky2scalar/permalink/810678552839038/
Is the 500- 50,000Hz a limitation of the scalar digitizer biofeedback? Will the GX scan up to 40MHz using the Tens Pads for Biofeedback scans?
Hi Arthur. Since the resonance frequency of the Scalar device is usually 5-6 MHz, you will want the modulation frequency to be significantly lower than the resonance Frequency. The Scalar Digitizer biofeedback scan goes to 50 kHz.
You can manually change the frequency to 40MHz under the “Control” Tab in the Spooky2 database.
What is the GX?
Hi Brian. Each GeneratorX contains 2 function generators, each with 2 outputs and full biofeedback function. GX can run at 40 MHz with any waveform, and can also load programs from Spooky2 software to run standalone without a computer. You can connect it with Scalar in the third mode – Rife Scalar to benefit from it.