Just like a radio, Spooky Scalar requires tuning. It is very simple to do. There are three different methods. You can choose which one you find easiest. The first two methods are the most accurate.
Place the Tune PCB on the Transmitter “Tuning PCB Position”. Turn the Tuning Adjustment knob anticlockwise until the lights on the PCB start to turn on. Then turn the knob 2 click positions clockwise so the lights are off. Remove the Tune PCB after tuning.
My pcb tuning device stay lighted when I take it off the dedigned place after the tuning. How can I get a new one ? Thanks
Dear Anne-caroline schwob, PCB tuning device does not retail. If you want to buy a scalar digitizer you can contact our service lady and we will add a free PCB tuning device in your packet.
Hello John,
Since some weeks I have my Spooky2-scalar device.
Still I stay unsure about the tuning:
I use your method 1 for tuning.
But:
At my found tuning-frequency of 5.5 MHz (with the 2 LED-s of tuning-device at the side of the transmittercoil just turned clockwise off again) the tuning light on my receiver is not lighting red at all (knob pushed in)!!
Is this still the perfect frequency, or should the red receiver light better glow up a little bit??
Yes, it is the perfect tuning. When it just lights up, turn about 2 clicks clockwise.